Pyro Industries Quest Plus Instrukcje Operacyjne Pobierz pdf (Strona 11)

General Operating Considerations

Proper Burn Characteristics:

The flame in your stove should be bright yellow under normal operation. If the flame becomes lazy with a

reddishlorange color, the damper position may need to be changed to provide more combustion air.

Excessive amounts of

flyash built-up in the grate, clinkers in the grate, or leakage of air (if the grate

not

properly seated) will starve the fire for air. (See ROUTINE MAINTENANCE for information on cleaning the

stove). If the problem persists, review the troubleshooting section at the end of this manual.

Pellet Feedpellet Size:

The pellet feed system is designed to handle a wide range of pellet sizes up to a maximum of 511

diameter.

Different pellets may feed at considerably different rates. You may notice a difference in the burn if you

change pellet fuel sizes. The longer the pellet, the slower

will feed and vice versa. If the stove will not

stay burning at the minimum fuel feed setting, those particular pellets may not be feeding fast enough. If

this happens, reduce the amount of combustion air by adjusting the collar on the damper rod. The factory

setting

2".

Long Burn Time:

The stove may be safely operated on a continuous basis, but

recommended that

be turned down

overnight or when the room

vacated for long periods of time. A

lb. bag of pellets should last

approximately

hours on high and over 24 hours on low, depending on the type and size of pellets you

are burning. Burn times will vary plus or minus 2 hours depending on the type of pellets burned.

NOTE:

It is normal for some ash to build up on the inner glass surface at the lower burn settings.

AUTOMATIC SAFETY FEATURES

Power Outage:

During a power outage, the stove will shut down safely.

will not automatically restart when the power

restored unless the exhaust temperature

still hot enough. The solid state control has an internal memory

that will retain heat output and blower speed settings through voltage interruptions. A small amount of

smoke may leak from the top of the window glass, the hopper and from the combustion air intake, if the

stove

vented horizontally. This will not persist for more than

to 5 minutes and will not be safety hazard.

It may set off your smoke alarm. To re-light the stove, follow the normal procedure for starting your stove.

Note:

the area

which you live is prone to frequent power outage, it

recommended that a minimum

(2.5

m) of vertical vent pipe be included in a freestanding installation to induce a natural draft

the event of a power failure.

Overheating:

A high temperature switch will automatically shut down the stove if it overheats. The stove will need to be

manually re-lit. Allow up to 45 minutes cooling time before re-lighting. Keep enough convection air going

through stove to keep

cooling properly, this will ensure long life of stove. If the overheating continues,

contact your dealer for more information.

Safe Shut Down of Your Stove:

Push the

Auger

ON/OFF

Switch

to the

"OFF"

position. This will turn the auger motor off and pellets will

stop feeding. Both blowers will continue to operate for a period of time (up to

minutes) until the exhaust

temperature cools sufficiently. The blowers will automatically turn off at that point.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Komentarze do niniejszej Instrukcji

Brak uwag

Pyro Industries Quest Plus Instrukcje Operacyjne Strona 11

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Piece Pyro Industries Quest Plus